IP Subnet Zero

I am sure you have used the Cisco IOS command show running-config before, and noticed a peculiar default command in the configuration. The command I am talking about is ip subnet-zero. Here is what I am talking about:


But what is this command? Why is it there? Let’s find out.
What is a zero subnet in the first place?

Before we talk about the command, let’s ask ourselves, “In the first place, what is a zero subnet?” Under old IP subnetting rules, the all 0’s subnet was reserved for the network, and the all 1’s subnet was reserved for the broadcast. Over time, engineers found that the all 0’s subnet wasn’t really used and, if it could be handed out as a useable network, many IP addresses could be changed.
An example of an IP address that is using a zero subnet is 10.1.0.1 with a subnet mask of 255.255.255.0. This IP address may look pretty weird to you. Some people may even try to argue that it is an invalid IP address because there is a 0 in third octet. However, today, this IP address is perfectly legal when it comes to subnetting. Thus, if I had an IP address of 10.1.0.0 with a 255.255.0.0 subnet mask and wanted to subnet it, I could actually get 255 valid networks out of it by using the 0 subnet. In other words, I could have networks ranging from 10.1.{0-254}.X where the X represents hosts 1-254. This gives me room for networks 0-254, or 255 total networks, by using the 0 subnet.
Do I need to enable my router to recognize the zero subnet?

The quick answer to this question is NO. Your Cisco IOS router, by default, has the command ip subnet-zero enabled on the router. Because of this command, the zero subnet can already be recognized.


Do I really want to use the zero subnet?
Just because something is there, doesn’t mean you should use it. That is true in the case of the zero subnet. Because many people still believe that the zero subnet is not a legal subnet, I would avoid using it if possible. I would do this just to avoid confusion when it comes to network configuration. On the other hand, if you work for a large Internet Service Provider and are handing out blocks of IP addresses, I would definitely hand out the zero block to help conserve your IP address resources.
Summary
In this article, we learned the difference between the following 3 commands:

• ip default-gateway
  
• ip default-network
  
• ip route 0.0.0.0 0.0.0.0 (configuring a default route)
  

The default-gateway command should only be used when a router is functioning as a bridge. The ip default-network and ip route 0.0.0.0 0.0.0.0 commands should be used to tell the router what route to select as the “gateway of last resort”.

Thanks brother decent effort on the Higher Paper Forum

Praise be to Allaah

رائع